Application Technique plaster.

Apply the plaster can be different ways - spread and throw. Smearing a fairly easy technique, but applies only to the thick solution. Much harder throwing, but they can cause any solutions. On concrete surfaces, the thickness of the plaster should be up to 5 mm, on brick -5 mm or more, on wooden - not less than 25 mm. In residential buildings, mortar plaster is applied in three layers. Apply the plaster can be different ways - spread and throw. Smearing a fairly easy technique, but applies only to the thick solution. Much harder throwing, but they can cause any solutions. On concrete surfaces, the thickness of the plaster should be up to 5 mm, on brick -5 mm or more, on wooden - not less than 25 mm. In residential buildings, mortar plaster is applied in three layers. The first layer - a spray, it is necessary to fill the surface roughness. The first layer is applied to a thickness of 3 to 9 mm, covering the entire surface. Consistency of the solution should be creamy. Before you apply this layer, the surface is moistened with water. For brick and concrete wall thickness of this layer to 5 mm, for wood - up to 9 mm. The second and main layer - ground. To make the soil more dense solution. This layer smooths irregularities on the surface. If necessary, primer is applied in several layers. The third layer of plaster - nakryvka has creamy consistency. This layer is applied to a thickness of 2-4 mm. The surface is leveled, formed a smooth layer, in the future it's easy to jam. Leveling mortar. After applying the solution to be distributed over the surface to make it smooth. Used for leveling or falcon poluterok. Leveling operation can be carried out in all directions, most importantly to get a flat, clean surface. Better use for this purpose trowel 0,75-1 m long with smooth edges. Grout plaster. This operation is carried out in order to obtain a smooth plaster surface. Spend grout when the third layer clutch long float. Hold the grater right hand presses it to the surface and drive in a circular motion counterclockwise. Smoothing is a kind of grout, using a special tool - trowel. After smoothing trowel with rubber gasket, the surface is more suitable for the application of glue paint if you use floats with a metal strip, the surface can be coated with oil paints.