Decorative tiles

In addition to gypsum plasterboard walls can oblitsevat asbestos cement slabs. Acquainted with them closer. Asbestos cement slabs - this cover sheet the size of 1200x600 mm and 6 mm thick. A distinctive feature of the finishing material is mirror smooth surface. Sometimes the surface of corrugated board and make it kind of mimics the tile size 150x150 mm. Another remarkable feature of asbestos-cement tiles is that they have a high moisture resistance. And that means they are ideal for finishing bathrooms, toilets, kitchens and successfully replace the ceramic tile. Surface preparation for finishing the asbestos cement slabs is the same as for other repairs. Necessary to seal the plaster solution large cracks and holes. Technology partial repair of the surfaces described above. After you clean and repair the surface, they are using a special adhesive (mastic) are fixed lists. How do you do it? Very simple. At the plate, and the ground surface using a conventional spatula or scraper "A layer of glue (mastic) 1-2 mm thick. To achieve a dense adjacency lists to the surface, you can use long strips, which are fastened to the wall with small nails in the joints of sheets and tightly pressed against the panel. After the glue (mastic) slats removed. It is desirable to strengthen the plates back to back each other. But it still does not avoid the gaps between the sheets. Close they can be decorative strips that need to consolidate immediately after the label sheet to the surface. Rails are attached with nails or screws. When the sticker sheet on the surface excess glue (mastic) can act in the gaps between panels. Removed once the solution is simple enough. Take an ordinary kitchen sponge and soak it in gasoline or kerosene. Then wipe the front surface of sheeting.