Defects wallpapering

Full or partial peeling wallpaper near the frieze, curb or on top of the walls. Wallcovering performed on a surface previously painted glue or lime paint, quick drying wallpaper for drafts or excessive heat, the use of liquid glue in tight wallpaper. When correcting a bend come off of the wallpaper, retouch Anew glue on the surface, fluff wallpaper adhesive to withstand the swelling and then pokleit. When pasting should avoid drafts and to use the adhesive in accordance with the density of wallpaper. Peeling wallpaper in casings and baseboards. Desktop and places have been badly missed attaching adhesive. When correcting wallpaper untuck carefully promazyvayut adhesive surface of moldings and casings, promazyvayut wallpaper, give them swell and then glued, well smoothed. Bubbles and wrinkles are formed due to slow drying due to low temperature, use a strong glue for thin wallpaper, negligent smoothing, wallpaper not sustained after smearing glue and not swollen. Desktop perekleit taking measures to improve the room temperature and removing the causes of inadequate ventilation. If you used a strong glue, replace it in accordance with the density of wallpaper. It's important to smooth wallpaper, soaking them lubricated for swelling the required time. Wallpaper in the corners of the walls are broken. Paper wallpaper when pasting glue expands, and when drying is greatly reduced. The angle was blocked solid fabric. Desktop perekleit so that the angle was covered edge wallpaper width 3-4 cm Thick seams. When the label of their new wallpaper seams coincided with the old wallpaper seams, which were not schischeny or dense wallpaper glued lap. Perekleit wallpaper, clear previously glued, stick tight butt wallpaper. Linen wallpaper are crooked. Sticker performed without punching a vertical line with plumb. Correction is possible only through the plywood. Edge of the wallpaper paste and covered with that through the tread and wallpaper. The sticker was performed with hot paste and penetrated the front of the wallpaper through the thin paper. Correction by plywood with cool or warm the glue with a temperature not exceeding 30 ° C. Visible seams. Pasting lap against the light. Correction by plywood, gluing start of the window opening. From under the new wallpapers are reviewed old. In the manufacture of wallpaper used aniline dyes instead of pigments. Replace wallpaper. The presence of solid inclusions under the wallpaper. Contamination of the glue or the surface of solids. Perekleit wallpaper, filter adhesive, or cleared the surface.