How to drill: helpful tips

Communications Before drilling the wall you should always check whether the selected location of water pipes and steam heating or electrical wiring. This is best done through a metal detector. This device responds to the steel, iron and nonferrous metals. It indicates the approximate depth of drilling and indicates the presence of conductive electrical cables. Communication Before drilling the wall you should always check whether the selected location of water pipes and steam heating or electrical wiring. This is best done through a metal detector. This device responds to the steel, iron and nonferrous metals. It indicates the approximate depth of drilling and indicates the presence of conductive electrical cables. Deep dust-free holes for dowels for plastic plugs hole depth must be greater than the length of the dowels. 10 mm is sufficient slack in the event that despite the careful removal, drilling dust still remains in the hole for the dowels. You can use the dust collection or just to blow a hole, but make sure to drill dust from getting into your eyes. If you want to remove the dust is even tighter, use a vacuum cleaner. To the metal drill was easier on a smooth surface like metal Your drill can easily slip off and you drill a hole, not where they wanted. To avoid this, before drilling punch a small hole in the metal. This usually takes punch - a steel rod with a tip at the end of that hammer driven into detail on the reverse side. In a small depression you are installing the drill. If the material is solid, you can first make a hole with a thin drill bit, and then expand the hole drill all desired diameter. Hold the tool correctly Always hold the drill straight and insert it vertically into the wall surface or part. If you work with more grip, you will be even easier to control the process of drilling. Sensitive organic glass openings in the organic glass to drill slowly, with a minimum number of turns - this material is very sensitive to heat and can melt. Adhesive for ceramic tile old Board of DIY: The smooth surface of the tile drill bit easily slips - but this can be avoided if, prior to the work of glue on the seat next hole patch, or a piece of duct tape. Bosch