Replacing the cartridge and plug.

To replace the cartridge, you need to unscrew the plug or turn off the breaker and remove the faulty cartridge. The new cartridge is necessary to understand, pass the wire into the hole on the cartridge, seal the wire ends, insulate them with electrical tape, attach to the terminals contact the core and Screw "skirt." To connect the appliance to the network use cords with plugs, which include sockets. From the frequent use of isolation from the cord exit holes of the body was ground plugs, wire wear and breakages occur. In this case, the wires are shortened to the point of termination, and after tinning loops again attached to the terminals of the contact pins. Need to ensure that the insulation reaches the terminal itself. In the plug has clamp screw with a bushing through which the wire is fixed to the body motionless. For greater reliability of the wire-clamping the cord in place to wrap the tape twice. You can not pull the plug from the socket by the cord. After assembly of the fork to check its contact with the socket. The plug should be firmly included in it. If the contact free, you can narrow or expand the socket pin. This can be done with a screwdriver that is inserted into the gap between the two halves of the pin and pliers "that compress the pin on the end.