Lost power.

Supply voltage can stop: a) in an apartment in this case blown protective tube or triggered circuit breakers. b) throughout the house in this case triggered protective system at home. To include it can only be representative of housing services. c) in the neighboring houses in this case disabled all the local power grid. Burnt cork is easily determined from melted wire - the fuse, which is located inside each tube. In automatic traffic jumped big button indicates that the voltage is turned off. Supply voltage in an apartment may stop or overload an electrical outlet, or damage of any appliance (lights, iron, cookers, stoves, radios, televisions, etc.). In this case, triggered safety devices (burning fuse plugs or disconnect circuit breakers). Before you install a new plug or turn the circuit breaker, turn off all electrical appliances. Moreover, if the new fuse blows or circuit breaker is triggered, then the wiring is shorted, remove which can only be a specialist. If the fuse does not go down, one after the other includes all appliances. If any appliance is defective, the fuse blows again. Thereby cause a short circuit is established and can be eliminated. If the fuse is not burned out after a series connection of all electrical appliances, make sure that was not exceeded provided for the fuse load. Fuse fuse me so much. At first remove the fuse from the socket body with a cartridge. Cartridge, replace the new one (same capacity) and the body are tight in the slot. If currently you do not have a spare cartridge, a burned-out can be recharged as follows. Remove the cartridge from the housing and clean. Then carefully with a screwdriver, pliers or a knife remove one of his two caps and pour through a hole sand. Remove the lid and the other, after which the channel cartridge insert new entries, with one end, fold and press the lid tightly to one patron. Around conductor roll in the sand poured first, free end of the wire, fold and press it onto the other lid. If the postings will be placed on the outside, that is wrong, short-circuit it may fall under the cartridge and continue to contact the network, ie at the removed fuse voltage may be in the wiring. New entries-fuse can be pulled out of the old flexible wire or cord. It should be a copper and a thin (1-2 wire-hairs). You can not use a steel wire. Instead of fuses appropriately apply automatic tube-fuses, which are screwed into their sockets and do not require replacement cartridge.