Repair of enamel bathtub or sink

Beaten off enamel bathtub or sink, you can restore dry whiting and glue BF-2 or the Phoenix. " To this end, the damaged area must be sanded clean up, wash with gasoline and dry well, then apply a small thin brush a thin layer of glue, add a little dry zinc or titanium white paint and mix them with glue and smoothed over the surface. So, repeat 3-4 times 1-1,5 hours to as long as the layer thickness is equal to the thickness of the enamel. Coating completely dries out for about four days at room temperature. You can use another method of fixing damage to the enamel - with the help of sodium silicate (silicate paper glue) and white cement. To do this, mix the cement with liquid glass until creamy state and cause the pre-trimmed seat this composition. It hardens within 4-6 hours. You can also use enamel KO-174 in aerosol packaging, specifically designed to restore the coating baths and other items. Method of application is described on the package. The full restoration of protective and decorative layer bath Here's one way. Bath thoroughly washed with hot water (75 ° C) with detergent powder, removing the contamination. The wet bath thoroughly degreased by wiping with a cloth dampened with mineral spirits, solvent, toluene, xylene solvents or complex industrial production number number 645, 646, 647. After drying, the dye bath enamels PF-115 or SD-41. The coating is dried for at least seven days at 18-22 ° C. Enamel coating bath can restore also with glue "Supercement. Clay is mixed with an equal amount of enamel paint NC-11 NC-26, etc. The bath is well degreased with white spirit or solvent, rub the swab moistened with xylene, toluene or their mixture with acetone. Prepared mixture of glue and enamel with the swab rubbed into the surface of the bath. Coating is dried for 24-36 hours, then applied a second coat. Operation is repeated four times. The last layer is dried 5-7 days. Should take into account the high flammability of these works.