Sliding doors

The door on the rollers on the guide is different fiber optic and convenience. The door of the house into the garden - like an invisible transition from a world of comfort in a world of beauty. One option - a sliding panel door. It opens by sliding along the inner wall. Similar constructions are used when not enough room to swing doors. The doors to the patio (courtyard) are sold in standard sets. Door on rollers on the guide is different fiber optic and convenience. The door of the house into the garden - like an invisible transition from a world of comfort in a world of beauty. One option - a sliding panel door. It opens by sliding along the inner wall. Similar constructions are used when not enough room to swing doors. The doors to the patio (courtyard) are sold in standard sets. They are ready for assembly. Frame included in the kit are made of aluminum, wood or plastic. Their width from 1800 to 6000 mm and height from 2100 to 2400 mm. Doors with wooden frame is more expensive but better for insulation. Popular type of patio door (shown on this page) has two door panels - fixed and mobile. Sold the three-and four-panel sets. In some suites have stretchers. They are inserted into the openings before you start mounting frame and door panels. Installation, start with the opening. Watch for its upright position and angles. Leave a tolerance of 3-5 mm on each side. Bottom of the opening should be flush with the floor or slightly higher. If the edge of the aperture coincides with the horizontal water-resistant lining, you just have to enhance its fiber cement. If higher, then put a new gasket on the bottom edge of the opening. Layer of cement mortar shall not exceed 10 mm, on top of it, place a strip of waterproof membrane. Make sure the gasket protruding slightly due to the plane of the masonry wall. Then put on top of pads for 10-mm layer of cement. Once the door panels will be installed, adjusted, fastened the lock and handle mortgage netverdeyuschuyu sealing putty in the joint between the frame and the brick wall outside. Now turn the plaster. It must be imposed in the space between wall and frame. 1. Seal box wedges. According to the instructions the company assemble the box. Together with an assistant lift the box and paste it into the doorway. Tip old - watch with the level of vertical and to ensure that the corners were straight. If necessary, drive in wooden wedges between the sidewalls of the box and the wall in places where the design will be fixed. At this time the assistant should monitor the verticality of the box. 2. Mounting box. An electric drill, drill holes through the shoals of the box. Drive in traffic jams, and attach the box to the wall. Head screws drown, fill in the holes of wood putty. 3. Setting a fixed panel. Check that the panel was properly inserted into the slots at the top and bottom of the box. Firmly slide the panel to the door jamb. Insert the threshold level in the slot between the fixed plate and the opposite jamb to secure the bottom of the fixed panel. Make sure that the step threshold is set tight, and fasten it with screws. 4. Installation of the separation strips. To strengthen the upper fixed panel, put between it and the side jamb trailing bar. Screw the divider bar that separates the sliding panel from the fixed to the lintel of the box. 5. Installation of the mobile panel. Work is performed outside the house. Insert the upper edge of the movable panels in the guide to the lintel of the box, then lower the bar on the lower track. Screw the panel to stop rolling guide to the top of the box. 6. Adjusting the movable panel. Check that the rollers move freely when opening and closing doors. If jammed, or, conversely, the course of shaky, adjust the clearance between the panel and the bottom of the box with screws in the socket casters. Movable panel should move without touching the door. Ural LTD