Warming of the door.

Loose installed exterior doors cause excessive cooling of the apartment. Such cooling may not only individually, but in apartment buildings. Leak resolved through the cloth to fit the door frame, using the jointer. If the door is new, then drying it after a while begins to warp. In this case, nailed to the frame strip of rubber or felt in the form of strips of 20-30 mm, providing a snug fit to strip closed the door. On a strip na distance of 3-5 mm from the plane door closed should impose a wooden rail and nailed her nails every 15-25 cm rod (casing), on the contrary, should be about 3-5 mm narrower sealing strips. The thickness of the slats should be 3-5 mm. Old door insulated by coating the entire surface of the solid fibreboard, and, with the door surface is removed decorative trim, so they do not interfere with tight fit plates to doors. Cutouts for handles, locks and eye make before attaching the plate to the wing. Before attaching the plate can be painted, for example, the color of the walls of a hallway or wallpaper paste over the same color and pattern, which are plastered on walls of the hallway. Another effective means of warming is the interior doors, which will be simultaneously more and acoustic insulation, and adornment. Upholstery must prepare leatherette or leather, cotton batting or polyurethane foam, ordinary and furniture nails with decorative cap. Door removed from its hinges, placed on two stools (stand), remove the handle, kljucheviny, number, eye and other protruding parts. Typically, door insulated from the outside only. More effect you will achieve if you make it from the inside. Depending on which way the door opens - indoors or out, can be 2 versions of the work. Consider the case when the door opens outward. From leatherette cut cloth, which is the length and width greater than the door leaf is 100 mm, and three bands of 120 mm: length of one is the height of the door, the length of the other two - its width. Along the lower and upper edges and the edge of the porch door leaf rollers suit. To this end, a cut of the band put on the appropriate edge of the door face down, stepping back from the edge of 15 mm, nailed them to the door. These bands impose twisted cotton wool (wadding) or foam rollers with a diameter of 30 mm. Stretch, leatherette wrapped on the roller and nailed him to the door so that the cushion half appeared over the edge of the door, and overlaps the gap between the door frame and door. The plane of the door leaf spread a foam or cotton batting and small studs fix it on the perimeter of the canvas. Top places leatherette, so that the side where the door is hung on hinges, leaf margin was 60-70 mm. Tuck leatherette and the porch and the edge of the nail small nails, making sure that the heads of nails that secure the cushion, were closed leatherette cloth. Just nailed cloth on top and bottom of the door. As a last resort, after the door hinges, attach the panel with a hinged side door (where the hinges are located), there does not need a cushion - hanging from the edge of the cloth nail furniture nails to trim. Many in the middle of the leaf nail furniture nails, sometimes with a fishing line or a special cable, leatherette cloth to the door, but it is necessary only if the wool is used and it is necessary to fix and prevent slipping. If you use batting or polyurethane foam, the nails with decorative caps will be needed only for edging parts: the larger the nail, the worse the sound insulation. Somewhat differently would have to act if the doors open into the room. Leatherette cloth cut out to exact dimensions of door leaf. Instead of three cut out a four-lane width of 120 mm and a length equal to the height and width, respectively, each side of the door frame (but not the leaf). Nailed to the bottom of the shaft door leaf so that when the door is closed, he went to the brink. Leatherette cloth spread on a layer of batting or foam and nailed construction studs first assessed the edge, then the bottom (it should be nailed to the door on the bottom cushion) and the upper edge of the cloth. Only then form the ridges on the two sticks of equity and top frame and nailed their furniture with nails so that the upper edge tucked leatherette overlaps the bottom. Upholstery will look nicer if the corners of cushions combine the "conditions". If the door stud on both sides, the simultaneous use of both the considered options.